2x stabilizer bearing 19mm for PORSCHE 911 G 2.7 930 -'77 PU bearing bushes REAR

2x stabilizer bearing 19mm for PORSCHE 911 G 2.7 930 -'77 PU bearing bushes REAR

For 19mm stabilizer

Description:
The most common cause of a stabilizer defect is damaged rubber bushings. As the rubber mounts become brittle, the stabilizer loses its damping over time. Due to the mechanical stress, the stabilizer rubbers become worn out and rigid after a certain time, which leads to rumbling noises in the chassis. Defective stabilizer bushings are also noticeable through spongy driving behavior when cornering.

SuperPro suspension bushings replace the original rubber bearings, which wear out quickly due to the susceptibility of the rubber material to environmental influences. Polyurethane, on the other hand, offers significantly longer durability and improves, among other things, handling and driving experience.

Please check the diameter of your stabilizer before ordering.



Attention: Not suitable for the original stabilizer with 18mm diameter!


SuperPro is a polyurethane suspension bushing manufacturer whose quality we rely on. PU can have very different material properties depending on the material composition and additives. With decades of experience, this Australian manufacturer is a leader in its field. SuperPro is considered the inventor of PU chassis bushings in the industry. The brand's design was often copied by market competitors, but the quality was never achieved. With these PU sockets you don't have to worry about noise, wear or material failure. All SuperPro sockets have TÜV approval.

Reference numbers:
91133379305,   911.333.793.05,   911 333 793 05
91133379300,   911.333.793.00,   911 333 793 00
91133379302,   911.333.793.02,   911 333 793 02


Scope of delivery:
2x PU bearings

Suitable for:
911 G until '77
911 turbo '75-'77
or vehicles with 19mm stabilizer