Speedometer disk for PORSCHE 964 993 Carrera rev counter with on-board computer
For the restoration or conversion of your speedometer
Description: Speedometer dials often fade over the years and are no longer easy to read. When restoring the instruments, it is therefore advisable to replace the speedometer dials. The speedometer dials also need to be replaced when converting imported vehicles from miles to kilometers. Here you get an elaborate reproduction made of polycarbonate. As the digitally printed speedometer dials may differ slightly in color from the faded original, we recommend replacing all dials for optimum results. On the 964 and 993, there were different variants for the speedometer and rev counter depending on the equipment (on-board computer, Tiptronic/gear shift). We have the different variants and the dials for the additional instruments in our program.
Note on installation: Do not tighten the fixing screws of the dial, but only lightly tighten them to the dial. Coat the threads of the screw holes (blind holes) with a little clear nail polish beforehand (use a toothpick). The nail varnish serves as a screw lock. Tightening too tightly will cause the varnish to peel off! To ensure even illumination of the digits, the dial must be glued back in place where it was glued at the factory using a lightly conductive adhesive (thin). We recommend "PolyMax-glasklar" from UHU. Caution, use very thinly!
You can find a puller for the speedometer needle under #5205
partworks GmbH is a German company that specializes in reverse engineering and the sale of spare parts for Porsche. Special emphasis is placed on high quality and excellent service. More than 130,000 car fans around the world are already satisfied customers of the Paderborn-based company. As a specialist company for classic car spare parts, we are aware of the quality requirements of our customers. That's why you can be sure that the requirements for new developments are based very closely on the original and sometimes even exceed them. With our own engineering department and internal testing, we can ensure the reliability of our products. Last but not least, our DIN-ISO-9001-certified quality management confirms the thoroughness of our work. If you see the manufacturer specification partworks, this means that it is either an in-house development or an article from an original equipment manufacturer (OE quality). Original equipment manufacturers are those manufacturers who have supplied the original product to the vehicle manufacturer but cannot be active on the open market under their own brand.