Digital clock for Porsche 944 951 a.m. in exchange

Digital clock for Porsche 944 951 a.m. in exchange

Description:
The old LCDs suffer from the demands of long lifespan and give up their function after more than a decade. The display of the climate control is also a typical defective component in the Porsche 944 and 968cs.

Perfomance:
This offer includes a repaired Porsche 944 / 968cs digital clock in exchange for your defective watch.
We can swap separate conductor tracks, burned -out capacitors, transistors and damaged housings, as well as scratched buttons and have a lavish spare parts reservoir. Basically, each clock receives a new, faithful display, conductor strips and new lamps. All components are cleaned before assembly. (Please note that we cannot repair watches with broken boards).

Insert/expansion instructions:
1. Loosen the triangular, black plastic cover at the end of the dashboard.
2. Loosen the screw underneath of the long, thin switch strip.
3. Carefully pull off the buttons of the two sliders of the heating/climate control with a small slot screwdriver or plastic spatula.
4. Carefully remove the cover cover of the heating/climate control with a plastic spatula or very small slot screwdrivers from the side. The aperture is attached with four (two top, two below) small clips. Be careful, the old plastic parts break easily. Loosen all four screws of the control panel and pull it up one centimeter.
5. Turn the inner sensor rosette (small, round grid) carefully by around 30 degrees to then take it out. Loosen the screw behind it.
6. Loosen the cover to the left of the right fan grille and the screws behind it with a small slot screwer.
7. Now you can easily take out the switch strip and solve the watch with your 2 screw connections. The somewhat heavy plug is not clipped and is simply pulled off.
8. Keep the screws well and look forward to the new watch. The installation takes place in reverse order.

A notice:
Make sure that the hose of the inner sensor has not slipped and ideally use a cable tie for fastening.
Duration:10 min

Tip:
Avoid the purchase of a “still” intact, but never general digital clock. It is only a matter of time before it also sets its function. Better save time, money and anger.

+ Fast processing
+ You can replace the car directly on the car for a new one
+ Possible optical defects are eliminated

After the repair, no programming or the like is required.

Porsche original part General overhaul means you get an original Porsche article that our industrial partners have been newly prepared for you.

Process for the exchange procedure:
A core deposit is charged on your old component.
This amount is automatically added to your shopping cart and billed.
After receiving and inspecting your old components, we will refund the deposit amount automatically.

Please understand that we can only accept original and undamaged parts (only normal wear and tear). Please send us the core in the same condition as the reconditioned part (screws, applications, etc.). Cores with atypical damage cannot be reconditioned and will need to be returned to you. This is the only way we can maintain the exchange process.
The old part must be returned within one year, otherwise there is no entitlement to a refund.

Further information on the exchange process, unacceptable damages, and core deposit can be found here: https://partworks.de/partworks/en/submenu/service/deposit/

Shipping outside the EU countries is not possible.

Reference numbers:
9446419130001c
94464191300, 944.641.913.00, 944 641 913 00
9446412130001c
94464121300, 944.641.213.00, 944 641 213 00


Scope of delivery:
1 digital clock in exchange

Suitable for:
Porsche 944/968cs

Path:
100 €