2x stabilizer bearing 20mm for PORSCHE 911 G S SC 930 up to -'86 PU bushes FRONT

2x stabilizer bearing 20mm for PORSCHE 911 G S SC 930 up to -'86 PU bushes FRONT

For all G models up to '86

Description:
The most common cause of a stabilizer defect is damaged rubber bushings. As the rubber mounts become brittle, the stabilizer loses its damping over time. Due to the mechanical stress, the stabilizer rubbers become worn out and rigid after a certain time, which leads to rumbling noises in the chassis. Defective stabilizer bushings are also noticeable through spongy driving behavior when cornering.

SuperPro suspension bushings replace the original rubber bearings, which wear out quickly due to the susceptibility of the rubber material to environmental influences. Polyurethane, on the other hand, offers significantly longer durability and improves, among other things, handling and driving experience.

Please check the diameter of your stabilizer before ordering.

SuperPro is a polyurethane suspension bushing manufacturer whose quality we rely on. PU can have very different material properties depending on the material composition and additives. With decades of experience, this Australian manufacturer is a leader in its field. SuperPro is considered the inventor of PU chassis bushings in the industry. The brand's design was often copied by market competitors, but the quality was never achieved. With these PU sockets you don't have to worry about noise, wear or material failure. All SuperPro sockets have TÜV approval.

Additional Information:

● Inner diameter: 20mm


Reference numbers:
91134379203,   911.343.792.03,   911 343 792 03


Scope of delivery:
According to illustration

Suitable for:
911G '74-'85
930 turbo 3.3 -'84
911 turbo 3.0
with 20mm stabilizer bar at the front