2x wheel bearing for PORSCHE 924 2.0 125hp 914 FRONT SET SKF
Including protective cap, washer and split pin
Description:
Wheel bearings on vehicles are the central roller bearings that guide the wheel over the wheel hub in the wheel carrier. In older vehicles, these are often pairs of bearings, e.g. deep groove ball bearings and needle roller bearings; newer models usually have double-row angular contact ball bearings. In the past, open roller bearings with separate shaft seals were also used. Thanks to "functional integration", these have now been replaced by bearings lubricated for life. If a wheel bearing is defective, this is usually noticeable through "humming" noises when cornering. A bold wobble on the wheel can also provide information about the condition of the wheel bearings. At Porsche, the design of the wheel bearings can also vary within a model series depending on the model year. Here you will find a small selection of wheel suspension ball bearings for the front or rear axle of your Porsche.
Dimensions:
Inner diameter: 17.5mm/29mm
Outer diameter: 39.9mm/50.3mm
Width: 19.9mm/14.2mm
The SKF company was founded in 1907 in Gothenburg, Sweden, by the inventor of the double-row self-aligning ball bearing, Sven Wingquist. By 1920, it had established itself on all five continents and is now one of the market leaders in the production of various bearings, seals and lubrication systems.
Reference numbers:
311405625
311405625D
311405641B
311405645
311405641
311405645E
311405625E
311405625A
Scope of delivery:
According to illustration
Suitable for:
914 (1.7/1.8/2.0)
924 2.0 125PS
NOT for 914-6 / 931 turbo / 924S
Installation location front axle